Instructions
IMPORTANT: Always work on a cool clean surface in the shade. Always shake liquids well before and during use.
Lightly dusty vehicles – The dry towel approach
Step 1: Spray a light mist of 3D Waterless Wash to a section of a body panel.
Step 2: Using a clean, soft microfiber towel, spread 3D Waterless Wash over the surface to create at thin, uniform layer of product on the surface.
Step 3: Using a separate, clean, soft microfiber towel, remove any excess product and buff this section to a dry, high gloss shine.
Repeat this process to the rest of the car. For best results, use plenty of clean, dry soft microfiber towels.
More soiled vehicles – The wet towel approach
Step 1: Start by duking 6 or more clean microfiber towels in a clean water source and then wringing them out so they are wet but do not drip excess water if held in the air. Fold these towels 4-ways to create 8 sides for wiping body panels. These are your wet wiping towels. You’ll want an equal amount of clean, dry microfiber towels for wiping panels clean and dry.
Step 2: Next spray 3D Waterless Wash over a panel (or a section of a panel in the case of large panels) and allow the cleaning agents to go to work loosening and emulsifying loose dirt, dust, pollen, bug splatter and road grime.
Step 3: Using one side of a wet folded towel, wipe a panel, or a section of a panel in a back-and-forth serpentine motion starting at one end of the panel or section and moving your towel towards the opposite end of the panel or section. The goal is to capture the majority of any loosened dirt and grime in single pass onto your microfiber towel and off the panel or section of panel. When finished with this section or panel – stop using this side of this towel.
Step 4: Immediately afterwards, before the 3D Waterless Wash can flash, re-wipe this section or panel using a separate, clean, dry soft microfiber towel to a high gloss, dry shine.
Repeat this process to the rest of the car always switching to an unused side of your wet microfiber towels for the initial cleaning wipe and the following this with a dry microfiber towel for the final buff.
