Mode d'Emploi
Directions
Before installing this coating, make sure to perform these steps depending on the vehicle/surface condition.
AUTOGRAPH Advanced Graphene Ceramic Spray Coating will only deliver the promised performance and durability if these steps are precisely followed.
- Deep clean the vehicle, making sure to remove any previous protection.
- Remove all ferrous and other contaminants using PURGE paired with a clay towel. We suggest using ORIGIN shampoo or SYNERGY rinse-less wash solution as a lubricant to prevent causing damage to the paint.
- If desired, proceed to paint correction/enhancement using filler and oil-free correction compound, and polish pop up that gloss through the roof.
- Prepare the surfaces by cleaning all residue left using REVEAL pre-coat surface prep fluid to assure optimal coating bonding to the vehicle surfaces.
- Agitate AUTOGRAPH’s container vigorously before application
- Spray on a foam or microfiber applicator, and spread one panel at a time, ideally on an area not exceeding 40 cm by 40 cm.
- Wait for the coating to flash/haze, which should take somewhere between 10 to 20 seconds, depending on room temperature and humidity
Note: You will notice at some point, the microfiber feels a bit tacky when you make contact with the surfaces, meaning it’s now time to buff off
Wipe the coating off in a cross pattern, ideally using a long pile, edgeless microfiber towel, until the panel is smudge less.
- wait 30 minutes before applying a second layer (if desired)
- Allow 4 hours to cure before exposure to elements.
